Rule LP900S Lo Pro Series Automatic 900 GPH 12V DC Water Sensing Bilge Pump

Designed to bring pumping power to tight spaces. Rule LoPro series bilge pumps are only 2.25 Inches high. High or low water sensing mode – the pump starts when water reaches a 2 inch level, by turning the motor cartridge the wrong way up, the sensor is at 1.3 Inches electronic automatic mode – pump robotically turns on each 2.5 Minutes to check for water, and if it is detected the pump stays on until the water is gone fully rotating discharge body, entire body swivels as much as 180 degree, making the pump extremely easy to install threaded discharge nozzle, more than one ports are to be had for this pump, 3/4 inch straight, 3/4 inch right angle; 1 inch, 1-1/8 inch all ports are included backflow prevention, tricuspid check valves lend a hand prevent backflow horizontal or vertical mounting voltage: 12vdc drift: 900gph open drift at 13.6v Amp draw: 4a approx fuse size 7.5 (Amp) protection: tco port configuration: 3/4″, 1″, 1-1/8″ straight, 90 degree 3/4″ backflow preventer valve can be utilized with straight fittings drift rate 900 (GPH) 3407 (lph) port type 3/4″ (19mm), 1″ (25mm), 1-1/8″ (28mm) straight hose barb or 3/4″(19mm) 90 elbow dimensions (l x w x h) 9.35 X 2.3 X 2.3 (Inches) 237.5 X 58.4 X 58.4 (Mm).
Water sensing mode when water reaches certain level or electronic automatic testing for water each 2.5 Minutes
Entire body swivels as much as 180 degree, making the pump extremely easy to install
Backflow prevention, tricuspid check valves lend a hand prevent backflow
Horizontal or vertical mounting
Designed to bring pumping power to tight spaces, only 2.25 Inches high