Installation instruction:
1.Loosen the drain light
2.Run the cable leads thru the garboard drain opening and screw the drain plug light assembly into the existing garboard fitting .The garboard fitting is 1/2 NPT
3.Connecting the light wire to a 12-24V on/off switch. Plug within the waterproof connector
4.Attach the red lead the positive(+) with the included in line 3 AMP assembly fuse and the black lead to the negative (-)
5.Switch at the light to check if it works well
Packing include:
1* Drain Plug light
1*protective tube
Single LED 1.5W with 6 LED insides, total 9W super brightness. Bronze housing materials, 100% anti-corrosion.
Standard “1/2” NPT thread type, connected with 2 meters cable.
Connected with waterproof connector to be able to easy installation, no drilling hole are needed, just screw it into the holes for your boat.
Waterproof: IP68. Color: Blue/Red/Green. Connect to 12-24V battery or power sources only. Current working: 750MA, Luminous Flux 650 Lm.
Note: 1. Standard ½”NPT joint will also be easily intalled by your hands 2. Please use the light under the water and the test output will have to be DC12-24V. If not, the light will shut off in a couple of minute as it’s overheated design 3. Please don’t use any tools (like pliers and knife) to intalls the light as it should destroy the protecitve layer 4. Please don’t press the outgoing bulke or shake the wire hardly, or it’ll damage the driver









There are no reviews yet.