PerFit®
Showing all 2 results
-
Boats & Equipment, Electrical Equipment, Fishing, Fishing Watercraft & Trolling Motors, Interior LightsNEW 18-20′ PONTOON BOAT UNDER DECK LED LIGHTS | INCLUDES HARNESS & MOUNTING TRACK
New 18 – 20 Feet Pontoon Boat Under Deck LED Lights 100% Waterproof IP 68
Step 3 – Wire Harness Routing Your underdeck wiring harness is shaped like a large letter “V”. The base of the V connects to your helm wiring. The tips of the V plug directly into the plugs on the ends of your underdeck lights. IMPORTANT: One of the leads on your underdeck harness is longer than the other. Use this one for your port side light. Route your underdeck wiring harness along the top of your pontoon with other boat wiring. Run across the width of your pontoon boat with other wiring and a cross channel. Secure your underdeck wiring at least every 18″. Make sure the harness will not become snagged by a trailer or other obstacles that travel under your boat.
Step 1 – Mounting strip installation The best location to install your under-deck lights will be on the bottom of your pontoon deck with the light facing down. Lay out half of your mounting channel on each side of your boat. Measure your lights for their exact length and cut your installation channel to match. There is enough mounting channel to provide a continuous mounting surface for your underdeck lights. Center the lights on each side of your boat and remove the backing of the 3M adhesive strips and stick under your deck. If necessary you can use screws to secure the channel. In all cases, we recommend installing the lights so they reflect off of the water and your pontoon tubes. We do not recommend installing the lights so they can be seen in direct view from another boat. -
Boats & Equipment, Electrical Equipment, Fishing, Fishing Watercraft & Trolling Motors, Interior Lights
NEW 22′-26′ PONTOON BOAT UNDER DECK LED LIGHTS INCLUDES HARNESS & MOUNTING TRACK
New 22-26 Feet Pontoon Boat Under Deck LED Lights 100% Waterproof IP 68
Step 1 – Mounting strip installation The best location to install your under-deck lights will be on the bottom of your pontoon deck with the light facing down. Lay out half of your mounting channel on each side of your boat. Measure your lights for their exact length and cut your installation channel to match. There is enough mounting channel to provide a continuous mounting surface for your underdeck lights. Center the lights on each side of your boat and remove the backing of the 3M adhesive strips and stick under your deck. If necessary you can use screws to secure the channel. In all cases, we recommend installing the lights so they reflect off of the water and your pontoon tubes. We do not recommend installing the lights so they can be seen in direct view from another boat.
Step 2 – Installing the Under-Deck Pontoon Lights In most cases, it is easier to make the electrical connection to your underdeck lights at the stern of the boat. Starting at the bow end of your mounting channel, remove the double-sided tape backing and begin snapping the underdeck lights into place. Continue to the stern. Repeat on the other side of your boat. The design of the wire harness will allow you to run the lights in either direction or one in each direction. Once the lights are installed, apply a generous amount of silicon at each end of both lights to add extra waterproofing and strain relief for the wires.