Nimrod Ice Auger Adapter – Converts Hand Auger to Power Auger – Made in USA – #TONII – For Pin System Augers

Nimrod Ice Auger Adapter – Fits Mora & Lazer Strikemaster Auger & the Eskimo auger – Works Best With Nimrod SmartHandle – Just for new pin system augers, not a threaded Take care of – It is loose on the HT auger and isn’t advisable. – 8-3/4″ long – 3/4″ chuck where you connect auger drill – 3/8″ chuck where you connect drill – Convert your hand auger into a power auger the usage of a cordless drill! – Works with 3/8″ or 1/2″ cordless drill – Cuts up to 50 holes on a single battery charge – Cuts through 10″ of ice in about 8 seconds – Three-sided arbor prevents spinning – Made in Michigan for Lakco – An amazing product!!! – A should for the Ice Fisherman!!! – You’ll be able to use any 18 volt cordless drill (or larger 19.2 is also good), does not matter what brand, but needs to be 18 volt (or larger), not 12 or 14 volt. (NOT advisable for lower than 14.4 volt drills.) – NOTE: This is for adapter only, auger & drill aren’t included! This is only so you understand how it works! – NOTE: We have sold about 5000 of these during the last 7 years and only 3 people lost their augers. All three were when the guys put the drill in reverse; this loosens the drill bit. – **DO NOT flip from Forward to Reverse to back auger out of hole!!!** – DO NOT PUT DRILL IN REVERSE: PULL AUGER & CHUCK UP!!
Works With 3/8″ or 1/2″ Cordless Drills
Three-sided Arbor Prevents Spinning
Cuts Through 10″ of Ice in About 8 Seconds!
Lightweight and Easy to Take care of!
**For New Pin System Take care of Augers, NOT Threaded Take care of**